MODEL M200-S - ROTARY DRAW TUBE & PIPE BENDER

FEATURES:
• To program a bend, simply turn the degree hand wheel to the desired bend angle
(include spring back.) When performing a bend, the die head automatically stops at
the degree indicated on the numerical counter. Allows for accuratge repeatability when
performing one or multiple bends. No complicated electronics to program.

• Lead screw indicator ensures repeatable counter die positioning for multiple bends."
In return mode, the die head stops in the home position.

• Remote Operator interface allows operator to control the bend.
• Die sets are interchangeable with all RMD benders.
• Bend can be advanced after stopping machine, saves on set up costs (material savings.)

• All die sets are color coded for easy identification (green for pipe, blue for tube and
gray for square.)

SPECIFICATIONS:
• Power: 110 V, 1 HP, Single Phase, 20 amp, 60 cycle (other electrical specificaitons available.)
• Bend material: Round or square tubing, pipe, flat stock, angle iron, or solid rod.
• Fast Change Over: Dies and counter dies can be changed out in a matter of seconds,
no tools required.

• Maximum Bend Speed: 11 seconds on a 90 degree bend.
• Maximum Bend is 180 degrees (machine limit is 202 degrees.)

• Maximum Center Line Bend Radius is 9".
• Capacity is up to 1-1/2" Schedule 40 Pipe (up to 2.0" tube, depending on wall thickness and CLR.)
• Simple operating controls: On/off, forward/reverse, and degree handwheel.
• Custom dies available.
• Approximate Weight: Model 200-S, 400 lbs.

OPTIONS:
• Power: Three phase available Micro processor controls in place of dialing in bend angles.
• Rotary positioning table available in various table lengths for repeatable bends in a single
piece of material.
• Allows for accurate bends in varying planes, as well as consistent measurements between bends.

Back to RMD Benders